Van bi xả đáy bồn tank inox vi sinh nối clamp Inox Men

Sanitary Clamp Tank Bottom Ball Valve

Van bi xả đáy bồn tank inox vi sinh nối clamp

Name

Sanitary Clamp Tank Bottom Ball Valve

1.  Product Name: Sanitary Clamp Tank Bottom Ball Valve with handle/Pneumatic/Electric
2.  Valve Body Material: SS304 or SS316L
3. Seal Material: Silicon, EPDM, PTFE, Viton, NBR
4. Max. Working Pressure: 10Bar
5. Max. Working Temperature: -20 degree to +135 degree (EPDM)
6. Availably  size: DN15-DN100, 1/2″-4″
7. Availably connection: Weld, Clamp, Male, Female, Flange, or Combinations
8. Inside Surface Treatment: Ra≥0.4-0.8µm
9. Surface Treatment: Ra≥0.8-1.6µm
10. Availably standard: DIN, SMS, 3A, RJT, IDF, etc.
11. Operated Type: Manual, Pneumatic, Electric
12. Certification: ISO9001:2008, CE, 3A

PRINCIPLE:

This ball valve with special tank bottom flange connection, be welded on the tank bottom. The design of contour and radius have effective gravity discharge function. Also smooth taper hole and the sphere closely to the bottom, which prevent the medium from staying at the entrance of valve. Make sure drain smoothly.

 DESIGN FEATURES:

Small fluid resistance, resistance equal to same length section of pipe

Simple structure, small volume, light weight

Easy to operate, open and close rapidly, from fully open to fully closed only 90 degree rotation, convenient remote control.

Easy maintenance, simple structure, convenient to disassembly and replacement the seal, ice seal, PTFE sealing, at fully open or fully close, sphere and the sealing surface of valve seat are Isolate with medium.

When medium transiting, these will not cause erosion of sealing surface.

Connection: clamp, weld, thread, flange

Size: 1” – 4”

Standard: 3A, DIN, SMS, IDF, RJT, BPE, ISO

ApplicationThe series of this valve is a kind of automatically or manually manipulation of  butterfly type ball valve, because of its can be very good deal with viscous or medium with particulate, which is widely used in food, beverage, pharmaceutical and chemical industrial piping system, to regulate and control the medium flow in the system. 

Word Principle

This kind of valve can be handled both by electric or a pneumatic actuator also can operated by handled.

Electric actuator or pneumatic actuator is to revolve the axial movement of piston to be 90° rotation of valve shaft. So that the valve can be open or close.

In that case, the close can be control and achieve the task of switch. They have three type of actuator : normally open (NO) , normally closed (NC), air/ air (A/A).

Muti – position handle can used to 15° adjustment of valve 12 seat to clock open or close. In that way, the valve can control the flow.

Pulling handle can use to the 4 multi-function to lock open or close, In that way, the valve can control the flow.

Standard Design

Various satndards of valves can be provided to clinets: DIN,3A,SMS,IOS/IDF,BS/RJT,ASME/BPF etc.

The parts of valve usually include: valve body divided into two parts, transfixion cavity sphere, stem and control sets (handle/actuator)etc. Have the series as follows: weld,clamp,weld/clamp etc.